cancel
Showing results for 
Search instead for 
Did you mean: 

BD8800 Hitless Upgrade Questions

BD8800 Hitless Upgrade Questions

Mrxlazuardin
New Contributor III
Hi,

I have done a half of hitless upgrade procedure of BD8800 with following "show switch" output after that.
Slot: MSM-A MSM-B *
------------------------ ------------------------
Current State: BACKUP MASTER
Image Selected: primary secondary
Image Booted: primary secondary
Primary ver: 15.7.1.4 12.5.4.5
Secondary ver: 15.7.1.4 15.6.1.4
Config Selected: primary.cfg
Config Booted: primary.cfgWhy there is no selected and booted config on MSM-A (backup, just upgraded)? Is it safe to do "run msm-failover" command on this situation?

Best regards,
3 REPLIES 3

Mrxlazuardin
New Contributor III
Hi Drew,

Of course, I have contacted GTAC and waiting for the solution. I post on this forum to see if somebody has same issue. Maybe there is some step by step with CLI output about successful BD8800 hitless upgrading procedure.

Best regards,

Drew_C
Valued Contributor III
Hi Lazuardi,
I think at this point, it would be best if you can contact our GTAC team.

Mrxlazuardin
New Contributor III
Any idea?
GTM-P2G8KFN