cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Boot Loop on resurrected X450e 24P

Boot Loop on resurrected X450e 24P

Simon_Bell
New Contributor
Hi all,

I'm trying to resurrect a long forgotten X450e. I powered it up with the intention of wiping the config as the credentials & IP are unknown.

I can see the boot sequence through the console and it throws up errors about "linkscan" and then reboots:

Starting ExtremeXOS 12.3.4b12Copyright (C) 1996-2010 Extreme Networks. All rights reserved.
Protected by US Patent Nos: 6,678,248; 6,104,700; 6,766,482; 6,618,388; 6,034,957; 6,859,438; 6,912,592; 6,954,436; 6,977,891; 6,980,550; 6,981,174; 7,003,705; 7,017,082; 7,046,665; 7,126,923; 7,142,509; 7,149,217; 7,152,124; 7,154,861; 7,245,619; 7,245,629; 7,269,135.

KICM: bcm_linkscan_register failed for unit 0, error -3!
KICM: bcm_linkscan_unregister failed for unit 0, error -3!
KICM: bcm_linkscan_unregister failed for unit 0, error -3!
insmod: init_module: kicm: Operation not permitted
Failed to open /dev/exosVlan (No such device)
****************************************************
EPM: can not install module exvlan going for reboot

****************************************************

I'm guessing this is telling me the switch is looking for a Master in a stack that it was once part of?

This error is stopping me from resetting the config as the switch never fully initialises.

I can get into the bootloader and have tried setting the image to null, but the above error keeps resetting the switch before I get a recovery logon prompt.

I've seen other articles that say updating the firmware through TFTP will fix this, but when I enter the serial number on the support page, I'm told no downloads are available for the switch.

I guess this is because it's out of maint, which is fair enough and I wouldn't expect to have access to the latest version of the firmware, but I would hope I can download the same version the switch is already running.

Any suggestions?

Cheers,

S.
11 REPLIES 11

Simon_Bell
New Contributor
Hi Konstantin,

unfortunately your colleages in GTAC have not been as helpful as you, and have closed the case ( Case#(01236953) ) without offering any assistance.

I've returned the Extreme switch to the junk store room and have used a Cisco device for this particular project.

Thanks for your help.

Kind Regards,

Simon

Korsovsky__Kons
Extreme Employee
Hi Simon,
are you able to boot it to login prompt? Could you try to run "REBOOT AS MASTER-CAPABLE" and then run "config none" from BootROM shell again?
Not sure if it will help but its good to try.

Konstantin

Hi Simon,
I'm not sure if you're already contacted GTAC for troubleshooting but if not just wanted to let you know that we have an article describing the same issue: bcm_linkscan_register issue.

Hi Konstantin,

I'm afraid not. Once the boot sequence hits the errors it triggers a reboot (see my original post), so I never get a login prompt.

Kind Regards,

Simon
GTM-P2G8KFN