C5/B5-Series LACP default settings

  • 0
  • 1
  • Article
  • Updated 5 years ago
  • (Edited)
Article ID: 13381 

Products
C5-Series, all firmware
B5-Series, all firmware 

Symptoms
Does not automatically form a dynamic Link Aggregation (LAG) upon ethernet cable attachment. 

Cause
Link Aggregation Control Protocol (LACP) is not enabled by default on a per port basis. 

On the C3, C2, B3, B2, and A2-Series products, LACP is enabled both globally and per port. 
On the C5 and B5-Series, the defaults are different: enabled globally but disabled per port. 

Solution
Use the 'set port lacp port <port#> enable' command to enable LACP on ports as required. 

See also: 5531 and 12516.
Photo of FAQ User

FAQ User, Official Rep

  • 13,620 Points 10k badge 2x thumb

Posted 5 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.