cluster config update rejected

[Jose_LV]

Hello
I have a cluster with 2 rfs 6000. Since yesterday, this event appears:
Err: cluster config update rejected - master does not accept full config.
And any configuration made in the active rfs is not replicated in the standby rfs

[Jose_LV]

Solved
Turning off and starting the controllers in order, first the active controller and then the standby controller, the cluster has been configured ok and the error has disappeared. The simplest solution at the end is the most effective.
Thanks everyone
Regards.

[Timo1]

Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem.

[Jose_LV]

Hi Timo
The priorities are configured with different values in the two rfs.
The rfs and the cluster were working well for a long time until the restart that was made yesterday.

the show cluster member command shows the two rfs and the show cluster status command shows one rfs in active and another in stanby in the cluster

[Daniel_Mejia]

Hi Jose,

Please reference the following KCS article on WiNG cluster configuration.

How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above