Configure VRRP Protocol

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Hello community.  How to configure VRRP between a SW BD8810 and WM3700?
Photo of Daniel Valera

Daniel Valera

  • 734 Points 500 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Alexandr P

Alexandr P, Embassador

  • 12,766 Points 10k badge 2x thumb
Hi!

You mean - BD and WM will be two VRRP instances with 1 VIP?
Photo of Daniel Valera

Daniel Valera

  • 734 Points 500 badge 2x thumb
Hi Alex.

(1)I have two BD8810 sw interconnected and two wm connected to each SW . I have a captive portal that runs on a WM. (2)I want to configure VRRP for the Captive Portal to run in a virtual ip for redundancy.

attached example
Photo of Brandon Clay

Brandon Clay, Escalation Support Engineer

  • 13,606 Points 10k badge 2x thumb
Hi Daniel,

You should be able to create the VRRP instance on the WMs with the commands below.
vrrp <vrid> interface vlan <vlan_id>
vrrp <vrid> ip <vrrp_vip>
Since this will be the same on both WMs, you should be able to put this config into the WM3700 profile.

-Brandon
Photo of Brandon Clay

Brandon Clay, Escalation Support Engineer

  • 13,606 Points 10k badge 2x thumb
I created a GTAC Knowledge article for this as well.