debug autonegotiation problem

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
We have some clients with gigabit TP NIC on a X450-G2 (EXOS V16.1.3.6 patch1-4) - but they only connect with 100MB full duplex. (i investigate the problem via trial and error)
My concern is now - how can i troubleshoot this from switch CLI?

1) How can i see more what happenend regarding autoneg on that specific port -  how can i increase log level to debug this ?
Which log modul have to be modified ?

2) On enterasys Switches (EOS) i could determine via "set port advertise" which speed or duplex modes are advertised to the partner AND which speed / duplex the partner offers.

System(rw)->show port advertise ge.4.36
ge.4.36 capability advertised remote
----------------------------------------------10BASE-T yes yes no
10BASE-TFD yes yes no
100BASE-TX yes yes no
100BASE-TXFD yes yes no
1000BASE-X no no no
1000BASE-XFD no no no
1000BASE-T no no no
1000BASE-TFD yes yes no
other no no yes
pause yes no no
Apause yes no no
Spause yes no no
Bpause yes yes no
How can i achieve this with EXOS ?


Regards
Photo of M.Nees

M.Nees, Embassador

  • 9,414 Points 5k badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Brad Parker

Brad Parker, Technical Support Engineer

  • 3,500 Points 3k badge 2x thumb
Official Response
Just to circle back, after a remote session, we were able to confirm that the partner device was advertising 10Mfd, 100Mfd, but not 1000Mfd. A feature request was also opened to expose those commands into the standard CLI instead of needing debug mode.