EMC Flexreport Device bandwitdh: shows only some kilobytes

  • 0
  • 1
  • Question
  • Updated 10 months ago
  • Answered
Hi,
when I look at  EMC 8.0.3 / Network / Devices / at one of our S-Series Switches, the flexreport for Device bandwidth shows a graph moving between 20 and 80 kbs. What is the source of this data? (The S-Series actually moves much more data around.)

It seems to have something to to with report "Top Devicess by IP Traffic". There are also shown quite small numbers.
Photo of htw

htw

  • 1,144 Points 1k badge 2x thumb

Posted 10 months ago

  • 0
  • 1
Photo of Bharathiraja, Suresh

Bharathiraja, Suresh, Employee

  • 3,442 Points 3k badge 2x thumb
Hi,

is this a default report ?customized one?

Thanks,
Suresh.B
Photo of htw

htw

  • 1,144 Points 1k badge 2x thumb
Hi, it's a default report.
Photo of Karthik Mohandoss

Karthik Mohandoss, Employee

  • 5,524 Points 5k badge 2x thumb
Hi,

The calculation of the report should be displayed below once you select it. 
Device IPv4 Bandwidth (kbps). Source (SNMPv1): ipSystemStatsInOctets + ipSystemStatsOutOctets Source (SNMPv2c/v3): ipSystemStatsHCInOctets + ipSystemStatsHCOutOctets
Photo of htw

htw

  • 1,144 Points 1k badge 2x thumb
Hi,
I found the definition of ipSystemInOctets:
    The total number of octets received in input IP datagrams,
    including those received in error.  Octets from datagrams
    counted in ipSystemStatsInReceives MUST be counted here.
    Are all switch/router-octets counted system-wide or only those going in and out the Management IP-Interface? (our S,K and 7100 Series deliver quite low values in the kbs range, our new test summits deliver none)