Enable availibilty at C5210 and have problem to view atatus

  • 0
  • 2
  • Problem
  • Updated 9 months ago
  • Not a Problem
  • (Edited)
I have two C5210 wireless controller and Enable Availibility and some AP status is at EWC1 is inactive and at other EWC (EWC2) is Active.
the other Problem  is I cannot Reboot AP by Controller.
 please help me to solve this problems.

thanks
Photo of Mikaeil Beigpour

Mikaeil Beigpour

  • 550 Points 500 badge 2x thumb

Posted 9 months ago

  • 0
  • 2
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 45,306 Points 20k badge 2x thumb
I strongly suggest that you attend the official training to learn more about the controller functions...

http://www.extremenetworks.com/education/courses/ESE-HI-1/

Let's assume you run v10 as you didn't mentioned the installed software version.
On controller#2 in the GUI > AP > APs > Foreign > select all > Actions > Release

That should terminate the tunnel from controller#2 to the APs and the APs should open a tunnel to controller#1

Cheers,
Ron
Photo of Mikaeil Beigpour

Mikaeil Beigpour

  • 550 Points 500 badge 2x thumb
thanks