cancel
Showing results for 
Search instead for 
Did you mean: 

Enterasys 3605 blinking red and green

Enterasys 3605 blinking red and green

Laura4
New Contributor II
I have Enterasys AP 3605. I approved it and it was working fine last week. This week, the controller says it's down. The AP is plugged in, but blinking red and green. Does anyone know what caused the AP to go down? I checked the log and it said poll timeout, but I have had other APs do that and come back up by releasing them from the backup controller. I tried rebooting it remotely, but that didn't do anything, and it's not active in the backup controller.
9 REPLIES 9

Raffi
Extreme Employee
If you are remote and looking at the leds is difficult, you can ping it or ssh to it to see what it is doing. If you know or can find the ip of the ap, ping it to verify it is up. You can ping /t for abit just in case it is rebooting. If you can ping, then we could ssh to it and do some troubleshooting to see what is wrong, and possibly fix it.

Doug
Extreme Employee
Check out the following GTAC Knowledge article to find out more on the diagnostic LED combos.... https://gtacknowledge.extremenetworks.com/articles/Q_A/What-do-the-AP3610-LED-colors-represent

This should help.

-Doug
Doug Hyde
Director, Technical Support / Extreme Networks

Doug
Extreme Employee
Laura,

Which LEDs are lit? If the access point is facing you with the logo towards you, read the LEDs from 1-4 left to right.

235fd1d55a01460d9114d125f220dc98_RackMultipart20150602-4148-1pge6k2-APled_inline.jpg



Doug Hyde
Director, Technical Support / Extreme Networks

Doug
Extreme Employee
Take a look at the following to see if it helps....

https://gtacknowledge.extremenetworks.com/articles/Solution/IdentiFi-Access-Point-No-Longer-Boots-or...

Doug Hyde
Director, Technical Support / Extreme Networks
GTM-P2G8KFN