Enterasys transceivers on extreme switches

  • 0
  • 1
  • Question
  • Updated 1 year ago
  • Answered

Hi , 

I want to use the below transceivers on the extreme summit switches. If yes on which which summit switches.

MGBIC-LC-09


MGBIC-LC-01


Thanks

Syed 

Photo of Syed Arshad

Syed Arshad

  • 204 Points 100 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Hernandez, Joshua

Hernandez, Joshua, Employee

  • 1,564 Points 1k badge 2x thumb
Syed Arshad,

It is possible that these Gigabit transceivers will work on EXOS switches; however, if possible put the optic in an EXOS switch and with a cable connected run the following command and provide the output.

debug hal show optic-info ddmi port <port#>

This output will provide some additional output.
Photo of Syed Arshad

Syed Arshad

  • 204 Points 100 badge 2x thumb
I do not have them with me. 

Did you try using them and they worked fine ?
Photo of Nick Yakimenko

Nick Yakimenko

  • 2,404 Points 2k badge 2x thumb
You should try them yourself, in most cases 3rd party transceivers work well
Photo of Jason Parker

Jason Parker, Employee

  • 2,908 Points 2k badge 2x thumb
There was a display issue is earlier firmware that would report "not supported " on some transceivers but that has been addressed so it is always a good point to upgrade but if the traffic passes without any issues you should be good to go.
Photo of Daniel Coughlin

Daniel Coughlin, Employee

  • 2,618 Points 2k badge 2x thumb
The release notes are the go to documentation for these questions.  If it is listed in a release as supported then it should be. If there are issues let us know.