enterasys xp 2400-256

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
when the router boots up and you run the show command the Ethernet ports show as being disabled, however when you plug in an Ethernet cable the port comes up. is there a way to enable the ports, and change the admin state, as the show port status say admin state down.
Photo of mark

mark

  • 190 Points 100 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Bastian Sprotte

Bastian Sprotte, Employee

  • 1,610 Points 1k badge 2x thumb
hello,
in the config mode you can use the command "show"
this now will show the config with line numbers #.
to remove commands you enter "negate #" and "save active".
now the config remove the line numbers.
regards
Photo of mark

mark

  • 190 Points 100 badge 2x thumb
Thanks for the reply, if i do a show command, line 1 for example has :- port disable et.1.1 im looking to enable this port.
Photo of Bastian Sprotte

Bastian Sprotte, Employee

  • 1,610 Points 1k badge 2x thumb
use the command
negate 1
save active

this should cause the disabled port will be enabled
-
Photo of mark

mark

  • 190 Points 100 badge 2x thumb
Thanks bastian ... this was doing my head in lol. if i do a show port status on et.1.1 link state is up and admin state is up now.