equivalent to "show ipfdb" command on xos

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
I am trying to figure out the layer 3 capacity of my x440 switch. Is there a "show ipfdb" command like there used to be in extremeware os?
Photo of Kaon Thana

Kaon Thana

  • 256 Points 250 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Colatuno, Joe

Colatuno, Joe, Escalation Support Engineer

  • 1,096 Points 1k badge 2x thumb
Official Response
Hey Koan,

Are you looking for the iproute capacity or IP ARP table capacity? 

show iproute and show iparp should give you what you need.  If you are looking for mac address table than you would just run show fdb.

For specs regarding maximum allowed entries look no further than the data sheet for the x440 http://www.extremenetworks.com/product/summit-x440-series

Regards,

Joe Colatuno
Escalation Support Engineer