cancel
Showing results for 
Search instead for 
Did you mean: 

EWC: AP Accessibility Report does not show any values

EWC: AP Accessibility Report does not show any values

M_Nees
Contributor III
What conditions must be set that the AP Accessibility Report show any data ?
(Something to active or some special AP familiy)

196d5346ab2c4d5a81d80528ea758ab1_RackMultipart20170303-22454-1i2mdue-AP_Accessibility_inline.png


A lot of my installations shows there no values (only zeros) or only 0,x values.

What is the benefit of this report ?? In which szenario can help me this report ?
(Why does Extreme create this report ?)

Manual is very poorly - no answer there regarding this question!
http://documentation.extremenetworks.com/wireless/ug/wireless/user_guide/c_ap_accessibility_report.s...
GTAC KB also.

Hopefully some here can help me.

Regards
7 REPLIES 7

Umut_Aydin
Extreme Employee
Hi,

FFI

you have the check this screen more often and chekc if really nothing shown.

But here more info's.

Q:
Why does the “cur” value for tx dissasoc show 0.13, should it not be 4 in 1 sec? Equally the peak should stay at 4 until 4 in a sec is exceeded? Similar can be seen in the other columns, Assoc req rx, reassoc req rx etc.

Can we have some details on how these numbers are calculated, I also noted there is a delay probably caused by the controller needing to receive data back from the AP that might skew these counters a bit more.

A:
The stats are collected as simple numbers of assoc, disassoc, etc. from the ap once every 30 seconds and calculated accordingly. The 4 disassoc in 1 sec becomes 4 disassocs in 30 sec which is the 0.13 disassoc/sec current value reported.

Also the algorithm for running average is:
Current average = 0.2 * current value + 0.8 * last average

Old values are overwritten since we are reporting a current and average value on a 30s cycle.

If nothing happanes after 30s it could we that we see only zero's.

Regards

Umut Aydin

Gareth_Mitchell
Extreme Employee
Matthias/Ron

I see the same behaviour in my lab, I will find out about this and let you know.

Regarding the documentation, please leave feedback there as well.

-Gareth

Documentation Feedback is given ...

Hi Gareth,

thanks for taking care.

For tracking this issue - GTAC Case: 01295841

Regards
GTM-P2G8KFN