Extreme Wireless Analytics

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
Hi All

I recently upgraded my wireless controller to the new FW Version 10.11.01.0210
This new firmware includes L7 analytics and Policy with out the need for a separate Purview appliance setup.

Reading the help file:

The Applications by WLAN pie chart displays the top 5 application groups running on that WLAN. ExtremeWireless cycles through the active WLANS displaying statistics. To view detailed statistics, enable Application Visibility during the WLAN configuration; then, on the Home dashboard, click the displayed pie chart under Applications by WLAN. Or, click Enable Application Visibility from the Home dashboard.

The controller and AP capture statistics for 31 pre-selected application groups. The top 5 application groups are displayed based on bytes and throughput over the last two-minute measuring period. The stats for each WLAN display for 30 seconds on a continuous cycle. Historical statistical data is available from ExtremeCloudTM and Extreme Application AnalyticsTM

The last line revers to the historical stats being available in the Extreme Application analytics.

So the question do I have to configure the controller/AP in Oneview the same way that you configure the Purview appliance in Oneview??

Thx

Andre

Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,160 Points 5k badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 47,404 Points 20k badge 2x thumb
I'd say that sentence mean that you need Purview (=Analytics) - so no history data if the controller is standalone without Extreme Management Center.

Where in the "Reports" section could I find the "Applications by WLAN" report - doens't make much sense to me that I'd only start that one from the dashboard.