Firmware Version 10.21

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
Hi all

I have been following the launch of the new 3912 and 3916 AP's.
I am very excited about the new models.

I see the new AP's is launched with the new Ver 10.21 firmware.
Can we get access to the new firmware?
Under my downloads I only have access to ver 10.11...
If not do you have release notes available?

Thx
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,380 Points 5k badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Eichholz, Alexander

Eichholz, Alexander, Employee

  • 114 Points 100 badge 2x thumb
Hello Andre
FW 10.21 is not yet released. Not even internal.
You will see an update on this if you are registered to the WLAN info or just contact our GTAC and ask 4 early adoption.
Alex
Photo of Hartmut Sachse

Hartmut Sachse

  • 2,598 Points 2k badge 2x thumb
I need early access too and an AP3912i for use during a large site survey. I will open a GTAC case/request.
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 51,458 Points 50k badge 2x thumb
I wonder whether the dimensions in the datasheet are correct because in the pictures it doens't look like that the AP3912 has equal hight/lenght.

Dimensions per datasheet = 8.46” x 8.46” x 2.2” (21.5 x 21.5 x 5.6 cm)

Regarding the software, I think it will take some more weeks till the AP is shipped to the end customer.
Photo of Hartmut Sachse

Hartmut Sachse

  • 2,598 Points 2k badge 2x thumb
Hello Ronald,

this Twitter post in the included link show some picture of the new AP:

https://twitter.com/Aliyoussef_/status/793211794093404160
Photo of Umut Aydin

Umut Aydin, Escalation Support Engineer

  • 2,300 Points 2k badge 2x thumb
It should be 18.5 x 12.5 x 2.5 cm .
I will check if this get changed otherwise I will forward this for change.

Umut Aydin
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 51,328 Points 50k badge 2x thumb
Thx
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,380 Points 5k badge 2x thumb
So a question regarding the new AP3912.
Will the Ethernet ports support B@HWC controller?
It will be a nice feature to be able to tunnel the ethernet connected devices to the controller.

Thx
Photo of Andre Brits Kannemeyer

Andre Brits Kannemeyer

  • 5,380 Points 5k badge 2x thumb
Answering my own question, but Yes the Ethernet ports will allow Bridge@HWC.

Thx