G/D/C/B/A-Series f/w 6.03 Use of the LLDP-MED Network-Policy TLV feature

  • 0
  • 1
  • Article
  • Updated 4 years ago
  • (Edited)
Article ID: 12931 

G-Series, firmware and higher
D-Series, firmware and higher
C5-Series, all firmware
C3-Series, firmware and higher
B5-Series, all firmware
B3-Series, firmware and higher
A4-Series, firmware and higher 

One of the new features cited in version 6.03 release notes, in the 'What's New in 6.03' section, is a new TLV (Type/Length/Value) option enhancement to LLDP-MED (7573):
LLDP-MED Network-Policy TLV reduces deployment costs of VoIP deployments by enabling standards-based provisioning of VoIP phones. The switches can be configured to assign VLAN, QoS, rate-limiting, and others operational parameters for LLDP-MED enabled VoIP phones. When combined with Enterasys Policy at the edge, this is a powerful, low cost solution for deploying convergent networks. 

This document discusses the concept of configuring to use the new feature, including a sample configuration. 

The LLDP-MED Network-Policy TLV feature may be used to communicate some combination of VLAN, Priority, and/or DSCP value to an LLDP-MED-compliant IP Phone:
set lldp port network-policy voice state enable tag tagged vid <vlan
   cos <prioritydscp <dscp> <ports>
set lldp port tx-tlv med-pol sys-name port-desc  <ports>

Note: If just activating the above-stated tx-tlv advertisements does not have the desired effect, then consider activating all advertisement ('set lldp port tx-tlv all  <ports>').

Recognizing that an IP Phone typically transmits its traffic VLAN-tagged while its attached PC's traffic is transmitted untagged, the phone would accept and utilize those same values in its VLAN Tag (VLAN, Priority) and IP Header (DSCP)(5811). 

On the switch one might then configure Policy or DiffServ (5848) to interpret any incoming (probably DSCP) value to yield a Policy Role or DiffServ action. Since VLAN and Priority are directly assignable using Policy, it would make sense to advertise the VLAN and Priority via LLDP-MED only in the absence of Policy. However, this is totally up to the user, based on the network design. 

Here, LLDP-MED would replace the possible use of CiscoDP to communicate a "VVID" (Voice VLAN ID) to the phone (5831). With CiscoDP, if the design calls for the phone to use a Priority or DSCP value, this requires phone configuration. 

For more background regarding the LLDP command set, please refer to the Configuration Guide for your product and firmware line.
Photo of FAQ User

FAQ User, Official Rep

  • 13,590 Points 10k badge 2x thumb

Posted 4 years ago

  • 0
  • 1

There are no replies.

This conversation is no longer open for comments or replies.