Gateway address of the switch

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
Hello,

Normally on Enterasys Networks we can write,

set ip address 10.0.0.98 mask 255.255.255.0 gateway 10.0.0.254

but in new Extreme Networks we can not write that gateway address. Therefore, where should we need to define that gateway address and how ?

Thanks,
Best Regards
Photo of Erhan YILDIZ

Erhan YILDIZ

  • 294 Points 250 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Bill Stritzinger

Bill Stritzinger, Alum

  • 6,036 Points 5k badge 2x thumb
Erhan,

To define the gateway address in XOS you need to the following...

configure iproute add default x.x.x.x <vr vr-default or vr vr-mgmt> 

I would assume you are adding the address to the vr-default on a created vlan so the command would be "configure iproute add default <address> vr vr-default"

Bill
Photo of PARTHIBAN CHINNAYA

PARTHIBAN CHINNAYA, Alum

  • 4,382 Points 4k badge 2x thumb
There is no specifi command for gateway in exos

You can add a default route as it does the same .
Every exos switch works the same way