cancel
Showing results for 
Search instead for 
Did you mean: 

How can I over Netsight through the events of Syslog or Traps

How can I over Netsight through the events of Syslog or Traps

Jairo_Rojas_Her
New Contributor II
How can I in Netsight through the events of Syslog or Traps bring me the following data of the switch or Access Point?

SysName:
SysLocation:
SysContact:
System MAC:
System Type:
SysHealth check:
Recovery Mode:
System Watchdog:
Current Time:
Timezone:
Boot Time:
Boot Count:
Next Reboot:
System UpTime:
Slot-1:
Slot-2:
Slot-3:
Slot-4:
Slot-5:
Slot-6:
Slot-7:
Slot-8:

To generate the alarms through mail, I use the following fields:
Location: $ sysLocation
IP Address: $ deviceIP
SW Name: $ sysName
Date / Time: $ time
Message: $ message

Additional data
Model Team: $ chassisType
AlarmSource: $ alarmSource
Subcomponent: $ alarmSubcomponent
Event Details: $ eventTitle
Severity: $ eventSeverity
Category: $ eventCategory
Firmware Version: $ deviceFirmware
Device Status: $ deviceStatus

1 REPLY 1

Ty_Izzet
Extreme Employee
Jario, I am not sure I fully understand the question. But is it possible that some of the variables may be missing from the alarm configured? If that is the case then please review the following article:

https://gtacknowledge.extremenetworks.com/articles/Solution/Alarm-Manager-notification-sends-E-Mail-...

GTM-P2G8KFN