cancel
Showing results for 
Search instead for 
Did you mean: 

How do I test traffic between switches?

How do I test traffic between switches?

Rodrigo_Azevedo
New Contributor II
I need to do a test traffic on a ring network.
The idea is to test by generating traffic if links are at least close to the expected nominal speed.
Whats I need to do this test? How?

15 REPLIES 15

Rodrigo_Azevedo
New Contributor II
Thank you again,
I will read and do a test in the room.

One more question, with this test it is possible to pass by various switches until the end?

Drew_C
Valued Contributor III
Depending on what you configure, sure.

Rodrigo, chiming in here again since I brought up the test sets. All you need is a common layer 2 vlan between your two test points in your network.. We us JDSU and Accedian. In many cases some of the links we test may go through 8 or 10 switches with most being Extreme. It could be a vman between all of these or it could be a simple vlan between point A and Point B. It all depends on what kind of services you are trying to test... If you have a pair of test sets then you do not do anything different on the network side as one of the test sets will be generating the traffic and the other one is reflecting the traffic back so you can get Jitter, Latency, and packet lost... Look up RFC 2544 testing setups...
GTM-P2G8KFN