How to alert for uplink RX or TX errors on uplink port (XOS and netsight)

  • 0
  • 1
  • Question
  • Updated 5 months ago
  • Answered

Hello,

We use netsight 7.1 console to do basic traps and syslog.  Is it possible, that netsight could send me an email alert if a problem was seen on an *uplink* port to a stack.  I don't want to have to manually run a report, I'd like to have an email sent out like we have for our traps.

Setup:  460 g1s running 16 code (XOS) ports 1:53-54 are shared lacp

Sometimes the fiber at our locations degrades overtime and affects the uplink (Massive TX or RX errors are seen with the show port 1:53-54 rx or tx is ran). 

Is there a way for netsight or the switch itself to monitor these ports, so we can be alerted when things start building up?  We have port elements setup in netsight, but I can't seem to see any option that would fit in that setup.

Any other options you can think of?

Thank you,

Sarah


Photo of Sarah Seidl

Sarah Seidl

  • 1,226 Points 1k badge 2x thumb

Posted 5 months ago

  • 0
  • 1
Photo of Volker Kull

Volker Kull

  • 1,620 Points 1k badge 2x thumb
Hi !

If you see these errors on interface statistics for

Statistic Name: Interface % Error Packets. Source: ifInDiscards + ifOutDiscards + ifInErrors + ifOutErrors + ifInUnknownProtos

you can use a threshold alarm in Netsight alarm manager for %error packets. For this you need to enable interface monitoring (Monitor - Save statistics for 1 hour and then drop. Use this mode for threshold alarms.) on the ports you want to monitor.

I am not sure if you will see all the errors there but it can be an indicator.

br
Volker
Photo of Sarah Seidl

Sarah Seidl

  • 1,226 Points 1k badge 2x thumb
thanks for the idea, will check it out
Photo of Karthik Mohandoss

Karthik Mohandoss, Employee

  • 5,438 Points 5k badge 2x thumb
Photo of Sarah Seidl

Sarah Seidl

  • 1,226 Points 1k badge 2x thumb
That looks promising, thank you!