How to config dhcpv6 relay on summit-x440

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Hello All,

I would like to know how to add dhcpv6 relay on summit-x440 switch?
Anyone has experiences for it?

Thanks.

Regards,
Joy
Photo of Joy Liu

Joy Liu

  • 228 Points 100 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Hernandez, Joshua

Hernandez, Joshua, Employee

  • 1,564 Points 1k badge 2x thumb
Joy,

You can use the following command:

configure bootprelay ipv6 add <ipv6_address>
Photo of Sumit Tokle

Sumit Tokle, Alum

  • 5,738 Points 5k badge 2x thumb
It doesn't supported in older version for sure.
Photo of Kawawa

Kawawa, GTAC

  • 3,270 Points 3k badge 2x thumb
As outlined above by Hernandez, the command is:
configure bootprelay ipv6 add <ipv6-address>
The X440 should come with 15.x installed, with support for IPv6 already. All the best
Photo of Joy Liu

Joy Liu

  • 228 Points 100 badge 2x thumb

Hello All,

Thanks for all replies, and I found that it's a new cli command since 15.4.1.


Regards,

Joy