cancel
Showing results for 
Search instead for 
Did you mean: 

How to config Radius Realm

How to config Radius Realm

Li_Ping_Hsu
New Contributor II
Form Version 16.x show radius thate has Realm information

Realm :Any

from config radius command no include realm parameter.

Anyone konw how to set this parameter

4 REPLIES 4

Corrine_Johnsto
New Contributor
GOODNESS U SMART

Karthik_Mohando
Extreme Employee
"configure radius netlogin 1 server 1.1.1.2 client-ip 1.1.1.1 shared-secret 1234 vr "VR-Mgmt""

And if you add the netlogin key to the command before the index it will set the Realm to Netlogin

**Truncated output of "show radius**
Radius server : 1 Status is Active
host name :
IP address : 1.1.1.2
Server IP Port: 1812
Client address: 1.1.1.1 (VR-Mgmt)
Retries : 3 *
Timeout : 3 *
Realm : Netlogin
shared secret : #$9D35STS5EPKKghX+lPY=
Access Requests : 0 Access Accepts : 0
Access Rejects : 0 Access Challenges : 0
Access Retransmits: 0 Client timeouts : 0
Bad authenticators: 0 Unknown types : 0
Round Trip Time : 0

Karthik_Mohando
Extreme Employee
Hi Li,

I guess i misunderstood your question. may be here is the command you are looking for.

"configure radius 1 server 1.1.1.2 client-ip 1.1.1.1 shared-secret 1234 vr "VR-Mgmt""

Here in the above command i have only specified the index and not the realm and this server 1.1.1.2 is configured to Realm ANY

**Truncated output of "show radius**
Radius server : 1 Status is Active
host name :
IP address : 1.1.1.2
Server IP Port: 1812
Client address: 1.1.1.1 (VR-Mgmt)
Retries : 3 *
Timeout : 3 *
Realm : Any
shared secret : #$9D35STS5EPKKghX+lPY=
Access Requests : 0 Access Accepts : 0
Access Rejects : 0 Access Challenges : 0
Access Retransmits: 0 Client timeouts : 0
Bad authenticators: 0 Unknown types : 0
Round Trip Time : 0

I Hope this helps.

Karthik_Mohando
Extreme Employee
As per the command reference guide

"Switch management and network login use the same primary and secondary RADIUS servers for
authentication (only if the realm is not specified in the command).,"

The below command should configure the server for both Netlogin and mgmt-access
"configure radius primary server client-ip shared-secret 1234"

GTM-P2G8KFN