How to configure Extreme switches to securCRT ?

  • 0
  • 1
  • Problem
  • Updated 2 weeks ago
  • Solved
I'm trying to configure extreme switches parameters from GNS3 to securCRT but it dosn,t connect!

Photo of Mohamed Karamalla

Mohamed Karamalla

  • 84 Points 75 badge 2x thumb

Posted 2 weeks ago

  • 0
  • 1
Photo of Frank

Frank

  • 3,836 Points 3k badge 2x thumb
I assume that you can ping the switch's IP address from your workstation.
Did you "enable ssh2" either globally or just for the appropriate VR?
In the SSH2 configuration in SecureCRT, I have "Password" first, followed by all the other options - that way "password" gets attempted first.
You may (in SecureCRT) have to enable additional "Key exchange" options (SSH2 section) or/and additional Ciphers and MAC options (SSH2->Advanced in SecureCRT)

On 'older' XOS versions, you have to install ssh as an additional module (something-ssh.xmod, if I recall correctly) for the appropriate OS. I think it's bundled since 16.x, not sure what the first 20-something version was that had bundled ssh support.

Hope that helps,
   Frank

Photo of Brad Parker

Brad Parker, Technical Support Engineer

  • 3,632 Points 3k badge 2x thumb
Good response, Frank. I just want to add that 16.2 and 21.1 were the versions where the SSH xmod is built into the EXOS image.

Brad
Photo of Mohamed Karamalla

Mohamed Karamalla

  • 84 Points 75 badge 2x thumb
Very helpful .. I'll try thanks frank