How to create an LACP LAG on EXOS 21.1X?

  • 0
  • 2
  • Question
  • Updated 7 months ago
  • Answered
I'd like to create a simple 4 port LAG between an Extreme Switch (x460-G2) and a Brocade switch (that is already successfully setup for LACP)

I've never setup a LACP LAG on EXOS before.   Is there a guide for this?
Photo of Sean Scarfo

Sean Scarfo

  • 236 Points 100 badge 2x thumb
  • frustrated

Posted 8 months ago

  • 0
  • 2
Photo of Patrick Voss

Patrick Voss, Alum

  • 11,594 Points 10k badge 2x thumb
Hello Sean,

You follow the same procedure to create a lag and add "LACP" onto the end. Here is an article that shows this process:

https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...

Hope this helps!
(Edited)
Photo of Brian Austin

Brian Austin, Employee

  • 452 Points 250 badge 2x thumb
Sean, 
you can do this with the following command:

configure sharing <masterport> grouping <additional ports in lag> algorithm port-based lacp

additional information for this can be found here:
https://gtacknowledge.extremenetworks.com/articles/How_To/how-to-configure-sharing-LAG-LACP-in-Summi...
Photo of Bin

Bin, Employee

  • 5,372 Points 5k badge 2x thumb
Hi Sean,
Kindly share the good discussion about this topic in our Hub.

https://community.extremenetworks.com/extreme/topics/how-i-configure-lacp-between-extreme-and-cisco

Best regards
(Edited)