How to disable a port in sharing

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered

Hi All

How can I remove a particular port once it is configured as sharing?

Suppose the following is the command saved in switch.

“enable sharing 1:24 grouping 1:24,3:24,6:24 algorithm address-based L2 lacp”

Now I need to remove 6:24 from the following command. Is it possible if so I kindly request somebody to suggest me the command for the same.
Photo of Abdul Raheem

Abdul Raheem

  • 458 Points 250 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Henrique

Henrique, Employee

  • 10,302 Points 10k badge 2x thumb
Hi Abdul, please use the command below:

configure sharing 1:24 delete ports 6:24
Photo of Henrique

Henrique, Employee

  • 10,302 Points 10k badge 2x thumb
If you want to add a port to an existing LAG you can use the command below:

configure sharing <master_port> add ports <port_list>

You can find these information in the articles below :

https://gtacknowledge.extremenetworks.com/articles/Q_A/Can-I-add-ports-to-an-existing-share-group-without-loosing-configuration

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-create-or-delete-a-share-group-in-EXOS 
Photo of Abdul Raheem

Abdul Raheem

  • 458 Points 250 badge 2x thumb
Dear Henrique

Thank you very much for your quick support. It was realy helpul.

Thanks & Regards
Abdul Raheem 
Photo of Brad Parker

Brad Parker, Technical Support Engineer

  • 3,266 Points 3k badge 2x thumb
Hi Abdul,

The command would be

configure sharing 1:24 delete port 6:24
Thanks
Brad
Photo of Abdul Raheem

Abdul Raheem

  • 458 Points 250 badge 2x thumb
Dear Parker

Thank you very much for your quick support. It was realy helpul.

Thanks & Regards
Abdul Raheem