how to enable/disable trial license in extreme ware switches summit 400-24P ?

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Doesn't Need an Answer

Need to enable & disable trial License in Extreme Ware Summit 400-24P switch.

"show switch" output shows  : License:          *** ILLEGAL Advanced Edge ***.

Software Version: Primary EW Ver:   7.8e.4.1 [non-ssh]


Photo of Jitendra Patel

Jitendra Patel

  • 402 Points 250 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Thomas, Ajo

Thomas, Ajo, Alum

  • 252 Points 250 badge 2x thumb
Hello Jitendra Patel,

You can clear the license information by execute the below command:

#clear license-info

If the switch you are using is on a trial license, you will need to use an alternate command to clear license information on the switch.

#debug epm clear trial-license

Hope this will help you!
Photo of Thomas, Ajo

Thomas, Ajo, Alum

  • 252 Points 250 badge 2x thumb
Hello Jitendra,

I hope the below article may help you for the same:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-enable-trial-license/
(Edited)
Photo of Jitendra Patel

Jitendra Patel

  • 402 Points 250 badge 2x thumb

Dear Ajo,

Thanks a lot. I will try above. I already tried #debug epm clear trial-license. but it did not worked. It works on XOS switches.


Photo of Jitendra Patel

Jitendra Patel

  • 402 Points 250 badge 2x thumb

Dear Ajo,

I tried #clear license-info  also but it is not working on Summit 400-24P.

Photo of Grosjean, Stephane

Grosjean, Stephane, Employee

  • 12,850 Points 10k badge 2x thumb
The command sent were for EXOS, not EW.
Need to dig in some old and deep archive to find a way
Photo of Jitendra Patel

Jitendra Patel

  • 402 Points 250 badge 2x thumb
Sure !!! Will wait for your reply.
Thanks in advance.
Regards,
Jitendra C Patel