How do you reinstall an IOS onto a HP 4/8 san switch / Brocade 200E ?

  • 0
  • 1
  • Question
  • Updated 4 years ago
i have 2 switches both with no iOS and they repeat 


The system is coming up, please wait...Read board ID of 0x80 from addr 0x23
Read extended model ID of 0x19 from addr 0x22
Matched board/model ID to platform index 6

Read board ID of 0x80 from addr 0x23
Read extended model ID of 0x19 from addr 0x22
Matched board/model ID to platform index 6
Failed to Identify the drive
Checking system RAM - press any key to stop test

Checking memory address: 00100000

System RAM test using Default POST RAM Test succeeded.

Press escape within 4 seconds to enter boot interface.
Booting "Fabric Operating System" image.
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Booting "Fabric Operating System" image.
Resetting ATA controller.

Also i am unable to find a iOS. I dont not have a Brocade or HP service plan so i know they wont be of any help at all. i need a step by step procedure on how to install an IOS
Photo of Travis

Travis

  • 270 Points 250 badge 2x thumb
  • Frustrated

Posted 4 years ago

  • 0
  • 1
Photo of Sumit Tokle

Sumit Tokle, Alum

  • 5,738 Points 5k badge 2x thumb
Do you have any Extreme devices? 
Extreme devices uses XOS, but not the IOS.
Photo of Travis

Travis

  • 270 Points 250 badge 2x thumb
I was asking about a brocade 200e not a extreme networks switch

This conversation is no longer open for comments or replies.