IPFIX config on x460

  • 0
  • 1
  • Question
  • Updated 4 years ago
Create Date: Jul 24 2013 9:07PM

I am trying to configure IPFIX on an x460 and read the flow data in solarwinds NTA but receiving the following error (NTA error):

 

NetFlow Receiver Service [servername] received an invalid IPFIX template with ID 265 from device

 

After looking at the data being sent to the collector I seem to be missing both the INPUT_SNMP and OUTPUT_SNMP information that NTA relies on, (presuming this is the issue, please correct me if I am wrong) how do you configure the switch to provide the missing data?

 

current IPFIX config:

configure ip-fix ip-address xxx.xxx.xxx.xxx protocol udp L4-port 2055 vr "VR-Default"

configure ip-fix source ip-address xxx.xxx.xxx.xxx vr "VR-Default"

configure ip-fix ports 47 ingress-and-egress

enable ip-fix ports 47 ipv4

configure ip-fix ports 48 ingress-and-egress

enable ip-fix ports 48 ipv4

 

Show ip-fix

Global IPFIX State: Enabled
Domain:             0
Source (Exporter) IP:   xxx.xxx.xxx.xxx      Virtual Router:         "VR-Default"
Collector IP:           xxx.xxx.xxx.xxx
Transport Protocol/Port/State:  UDP, Port 2055, NA

Flow Keys:
IPv4:   "Source-IP"  "Source L4 Port"  "Dest-IP"  "Dest L4 Port"  "L4 Protocol"  "TOS"
Unused:

IPv6:   "Source-IP"  "Source L4 Port"  "Dest-IP"  "Dest L4 Port"  "Next Header"  "TOS"  "Flow Label"
Unused:

Non-IP: "Source MAC"  "Dest MAC"  "Ethertype"  "VLAN ID"  "Priority"  "Tagged"
Unused:

IPFIX Enabled on Port(s):    47-48

 

Any help/recommendations much appreciated!

 

Thanks

(from Keith_Betts)
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb
Create Date: Jul 25 2013 12:25PM

This has now been resolved,

Although I have been unable to find any documented fix for this in the xos release notes it works on xos 15.3, didn’t on 12.6 or 15.2.

(from Keith_Betts)

This conversation is no longer open for comments or replies.