ipsec on netiron CER 2024*

  • 0
  • 2
  • Question
  • Updated 3 months ago
  • Answered

Hi there!

I have 4 routers: 2x NetIron CER 2024C , NetIron CER 2024C-4X , NetIron CER 2048F

Could you please tell me, they support IPSEC? It is possible to configure them with IPSEC?
Photo of George Khan

George Khan

  • 110 Points 100 badge 2x thumb

Posted 3 months ago

  • 0
  • 2
Photo of Michael Dinius

Michael Dinius, Employee

  • 250 Points 250 badge 2x thumb
Photo of Michael Dinius

Michael Dinius, Employee

  • 250 Points 250 badge 2x thumb
this uis from the Support Matrx 6.200.
Hope that helps .
Photo of George Khan

George Khan

  • 110 Points 100 badge 2x thumb
Hi, Michael !
Thank u 4 ur reply! So, if i have on my CER 2024* firmware ver V5.8.0a , for me ipsec is unavailable - this correct? 
Photo of Michael Dinius

Michael Dinius, Employee

  • 250 Points 250 badge 2x thumb
correct. ( from the Matrix )
Encryption and decryption of IP packets and the tunnel setup using IKEv2 can be done only on the BR-MLX-10GX4-M IPSEC line card.
Have a look please into the "Security Configuration Guide"  page 203 ff.. for the features you looking for .
Photo of George Khan

George Khan

  • 110 Points 100 badge 2x thumb
But i cant see this features _only_ for mlx* series on http://www.brocade.com/content/dam/common/documents/content-types/configuration-guide/netiron-05900-... here is just examples with mlx ...
There is no modules with ipsec (ikev2) for CER 2000 (2024) series?
(Edited)
Photo of Michael Dinius

Michael Dinius, Employee

  • 250 Points 250 badge 2x thumb
yes   there are no modules with ipsec (ikev2) for CER 2000 (2024) series
Photo of George Khan

George Khan

  • 110 Points 100 badge 2x thumb
Ok, Michael , thank you so much! :)