K Series linecard failure notification

  • 0
  • 1
  • Question
  • Updated 2 years ago
  • Answered
I am attempting to configure Netsight to alarm when one of the linecards in a K series goes offline.  Is there a specific trap that will produce these results?  I have tried:
ctEntStateOperDisabled
extremeStackMemberStatusChange
extremeStackingPortStatusChanged

These will not produce an alarm for the K series.
Photo of Aaron Brunck

Aaron Brunck

  • 70 Points

Posted 2 years ago

  • 0
  • 1
Photo of Bob Maheu

Bob Maheu, Employee

  • 1,040 Points 1k badge 2x thumb
Hello,

If you look at the end of the release notes for the firmware that you are using on the K-Series you will see a list of traps that are supports.  In this case I would select the following traps as they should produce the results that you are looking for:

entStateOperDisabled
boardNonOperational
boardRemoval