cancel
Showing results for 
Search instead for 
Did you mean: 

K Series linecard failure notification

K Series linecard failure notification

Aaron_Brunck
New Contributor
I am attempting to configure Netsight to alarm when one of the linecards in a K series goes offline. Is there a specific trap that will produce these results? I have tried:
code:
ctEntStateOperDisabled 

extremeStackMemberStatusChange
extremeStackingPortStatusChanged

These will not produce an alarm for the K series.

1 REPLY 1

Bob_Maheu
New Contributor
Hello,

If you look at the end of the release notes for the firmware that you are using on the K-Series you will see a list of traps that are supports. In this case I would select the following traps as they should produce the results that you are looking for:

entStateOperDisabled
boardNonOperational
boardRemoval
GTM-P2G8KFN