lacp aruba

  • 0
  • 1
  • Question
  • Updated 10 months ago
  • Answered
When using LACP with Aruba controller after a few days it became intermittent. Is there anyone experienced this ? This is my sample config <enable sharing 1 group 1,2 LACP>
Photo of Elvin Manumbale

Elvin Manumbale

  • 150 Points 100 badge 2x thumb

Posted 10 months ago

  • 0
  • 1
Photo of Taykin Izzet

Taykin Izzet , Employee

  • 2,904 Points 2k badge 2x thumb
Elvin, can you check the following outputs when the issue occurs and determine whether the ports are active/ready, if there are any link up transitions, the show log output tells us if any ports in the LAG went down to either a local or remote fault, or any errors under the LACP counters output?

This will help us isolate whether if it is a port going down or if the issue is with the LAG.

# show sharing
Load Sharing Monitor
Config    Current Agg     Min    Ld Share  Dist  Ld Share  Agg Link  Link Up
Master    Master  Control Active Algorithm Flags Group     Mbr State Transitions
     1            LACP       1    L2        A     1         Y     A       1
                                  L2              2         Y     A       0
Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback

# show lacp counters
LACP PDUs dropped on non-LACP ports : 0
LACP Bulk checkpointed msgs sent    : 0
LACP Bulk checkpointed msgs recv    : 0
LACP PDUs checkpointed sent         : 0
LACP PDUs checkpointed recv         : 0
Lag        Member     Rx       Rx Drop  Rx Drop  Rx Drop  Tx       Tx
Group      Port       Ok       PDU Err  Not Up   Same MAC Sent Ok  Xmit Err
21         21         2        0        0        0        2        0
           22         2        0        0        0        2        0

The show log will help with any port down/up and sharing transitions.