cancel
Showing results for 
Search instead for 
Did you mean: 

lacp in x460-24t

lacp in x460-24t

sumeet
New Contributor
hi ,
i am using X460-24t extreme switch.
here is my setup

mydevice with two links configured in lacp mode --- extreme switch port 3
|
|
extreme switch port4
I have set vlan 3001 on port 3 as tagged with ip 172.16.254.1 . I run ping to it from my device with ip 172.16.254.2 .
I want to set lacp on port 3(master) and 4.
so , I ran
# enable sharing 3 grouping 3,4 algorithm address-based lacp
Question 1) had I used #enable sharing 3 grouping 3,4 lacp , what would be the difference ?
Question 2) Any specific command to see port sharing status ?
10 REPLIES 10

Kevin_Kim
Extreme Employee
You can just take out 'lacp' at the end of the sharing command.

# disable sharing 3
# enable sharing 3 grouping 3,4 algorithm address-based

sumeet
New Contributor
turns you my device has static LAG support without lacp .
What change should I do in extreme switch setting for this ?

Erik_Auerswald
Contributor II
If it works w/o sharing, but stops with sharing enabled (on one side), the other side seems not to use LACP. The "blocked" indicates that the port sharing is not active.

sumeet
New Contributor
as soon as I enable sharing .
my ping stops .
I tried
#show vlan3001
got
Ports: 1. (Number of active ports=1) Tag: *3gb
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (m) Mac-Based port

Don't know what blocked indicates ?
GTM-P2G8KFN