lacp with dell fx2

  • 0
  • 1
  • Problem
  • Updated 3 years ago
  • Solved
when I'm trying to configure lacp with dell server fx2, the port was active but the network is unreachable. when I show the sharing mem agg was no set. anyone can share how to solve this ?
Photo of Elvin Manumbale

Elvin Manumbale

  • 150 Points 100 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of André Herkenrath

André Herkenrath, Employee

  • 1,962 Points 1k badge 2x thumb
how did you configure the switch side ?

enable sharing x grouping x-y protocol lacp ?



  • 210 Points 100 badge 2x thumb
Hello Elvin, 

What did you configured in server end?
If you have configured teaming then no need to configured LACP in switch.  If you have configured LACP in server then LACP require in switch end.

Manas Ranjan
Photo of Jeremy

Jeremy, Embassador

  • 9,788 Points 5k badge 2x thumb
Yes, you will need to run LACP on the server side.  LACP works by sharing LACP-PDU... if one side isn't talking LACP, your link won't be active, although it may show physical link. 
Photo of Vellachery, Sumeesh

Vellachery, Sumeesh, Employee

  • 3,288 Points 3k badge 2x thumb

I have included an KB Article for your reference "How to configure sharing (LAG) with LACP on Extreme switches:-

Please click on the below-mentioned Article:-

To verify, if the LACP PDUs are received from the peer device, execute the following command "show lacp counters" on the Extreme switch and check if the counters in column "RxOk" are incrementing.

We could also apply the following ACL in the ingress direction on the corresponding port and check the output of "show access-list counter".

I have also included the KB Article for your reference which shows you a sample output of "show lacp counters" and the ACL Policy file.

Please click on the below-mentioned Article:-