Looking for OS on switches that will support TACACS+

  • 0
  • 1
  • Problem
  • Updated 1 year ago
  • Solved

Below is the current version we are running on some switches. Trying to confirm if this version can do TACACS+. If not, what version would be needed?


Verdiep1(su)->show version


 

Model           Serial #           Versions

--------------  -----------------  -------------------

 

B5K125-48       12070176225J       Hw:BCM56514 REV 1

                                   Bp:02.02.15

                                   Fw:06.61.07.0010

                                   BuFw:06.61.05.0009

 

B5K125-48       12070177225J       Hw:BCM56514 REV 1

                                   Bp:02.02.15

                                   Fw:06.61.07.0010

                                   BuFw:06.61.05.0009

 

B5G124-48P2     12170651225K       Hw:BCM56514 REV 1

                                   Bp:02.02.15

                                   Fw:06.61.07.0010

                                   BuFw:06.61.05.0009

                                   PoE:2_1

 

Photo of Jeff Sadowski

Jeff Sadowski

  • 70 Points

Posted 1 year ago

  • 0
  • 1
Photo of Daniel Coughlin

Daniel Coughlin, Employee

  • 2,608 Points 2k badge 2x thumb
I did not check that firmware specifically but the current should.
This is done on a c5 just as an example:
C5(rw)->set tacacs enable
C5(rw)->set tacacs server 1 192.168.10.10 49 mysecret
C5(rw)->set tacacs session accounting enable
C5(rw)->set tacacs session authorization service basic
C5(rw)->set tacacs session authorization read-write priv-lvl 5
C5(rw)->set tacacs command accounting enable
C5(rw)->set tacacs command authorization enable
C5(rw)->set tacacs singleconnect enable
C5(rw)->set authentication login tacacs
Photo of Erik Auerswald

Erik Auerswald, Embassador

  • 12,782 Points 10k badge 2x thumb
Hi Jeff,

I know of a customer who has been using TACACS+ with B5 switches since many years ago, using older firmware releases back then.

Erik
Photo of Daniel B

Daniel B

  • 360 Points 250 badge 2x thumb

Hi Jeff,

your version supports TACACS+ management support. Also, the release notes say: "TACACS+ using single connect is configurable through the CLI but it is not supported in this release"

I would use a newer firmware.

Regards Daniel