cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

make Vlan 800 Series

make Vlan 800 Series

LOSI_STEFANO
New Contributor
Can someone help me configure VLANs in a switch 800 series ??I created a VLAN 'phone' in addition to the VLAN 'default' but I can not figure out how to make them communicate.
10 REPLIES 10

Mike_D
Extreme Employee


Hello Losi,

The 800 - as already established - supports static routing.

Forwarding should be enabled by default.

I think we can help you out - but the configuration info given is confusing.

Can you label a simple diagram with addresses, gateway etc?

Stick figure simple. xx-----XX-----x or something similar? We should be able to clear up some of the muddle.

This

static route 192.168.253.1 with 192.168.250.0/24 gateway

seems wrong. but much depends on what was intended.

If you can describe what you would like to have happen for routing (vs the route statement above) I'm sure the community can help.

By the way, is the route being entered into the 800 series?

Regards,

Mike

LOSI_STEFANO
New Contributor
I have 2 VLAN (dafault, phone).'Default' has the interface ip 192.168.253.22 gateway with firewall (192.168.253.1)
'Phone' has Cooma interface ip 192.168.250.1

I created a static route 192.168.253.1 with 192.168.250.0/24 gateway but not working

Ronald_Dvorak
Honored Contributor
I don't think that the 800series could route - AFAIK you'd only configure one IP for mgmt of the switch but not different VLAN interfaces.

https://gtacknowledge.extremenetworks.com/articles/Q_A/Does-the-800-Series-support-Layer-3-switching

Based on datasheet it does support routing. It does have Routing section... It is quite confusing.
Regards Zdeněk Pala
GTM-P2G8KFN