MLAG configuration between two Black Diamond

  • 0
  • 1
  • Question
  • Updated 1 year ago
  • Answered
  • (Edited)
create mlag peer "CORE-A"

configure mlag peer "CORE-A" ipaddress 199.199.199.1 vr VR-Default

configure mlag peer "CORE-A" interval 1000

enable mlag port 10:47 peer "CORE-A" id 20

enable mlag port 10:48 peer "CORE-A" id 10 


What does above configuration mean ?


Photo of Sai Prasad Rao Rapolu

Sai Prasad Rao Rapolu

  • 1,494 Points 1k badge 2x thumb

Posted 1 year ago

  • 0
  • 1
Photo of Grosjean, Stephane

Grosjean, Stephane, Employee

  • 13,608 Points 10k badge 2x thumb
Hi,


this is the typical minimal MLAG config.

# Name of the other MLAG peer, to distinguish if several MLAG peers are present
create mlag peer "CORE-A"    

# IP address of the remote peer on the ISC vlan. Must not be routed
configure mlag peer "CORE-A" ipaddress 199.199.199.1 vr VR-Default

# the MLAG Id per port, must be identical on each MLAG peer for the same end-system
enable mlag port 10:48 peer "CORE-A" id 10
enable mlag port 10:47 peer "CORE-A" id 20

You also need to have the ISC vlan created with the correct IP address and all the necessary LAG created (10:48, 10:47) with LACP if needed.


Best Regards,
Stephane