Monitor AP4610 values via SNMP?

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
Hello

How can I monitor the following values of an AP4610 Extreme access point via SNMP?
- Number of devices currently connected
- Traffic on radio interfaces (Mbit)
- Mode and speed of the 2.4 ghz and 5 ghz radio interface

Many thanks in advance!

Lukas
Photo of Lukas

Lukas

  • 82 Points 75 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Taykin Izzet

Taykin Izzet , Employee

  • 2,924 Points 2k badge 2x thumb
Lukas,

The following OIDs may help:

-- 1.3.6.1.4.1.1916.2.131.50.1.4.3.2.11.1.1.12
                "Traffic Utilization Index
               
                Measures the efficiency the medium under consideration
                is used. It is the percentage of the current data throughput
                over the theoretical data rate limit, which is derived
                the current maximum physical rate configured over the medium
                based on past empirical data. This index could assist end user
                in site planning and expansion. The numerical value might be
                further classified as:
                  -1: no data available ( e.g. radio is not in wlan operation
                                          mode )
                  0-20 : very low utilization
                  20-40: low utilization
                  40-60: moderate utilization
                  60 and above: high utilization


-- 1.3.6.1.4.1.1916.2.131.50.1.3.33.2.1.5
                "The rf-mode of operation for the radio.
                Values:
                2.4GHz-wlan
                5GHz-wlan
                sensor
               

Let me know the results.

Thanks!
Photo of Bharathiraja, Suresh

Bharathiraja, Suresh, Employee

  • 3,526 Points 3k badge 2x thumb
Hi Lukas,

The SNMP tool which we talking about is Netsight or ridgeline ?

Thanks,
Suresh.B