netlogin commands doesn't exist in command line on X440G2 v21.1.1.4

  • 0
  • 1
  • Question
  • Updated 2 months ago
  • Answered
  • (Edited)
I'm configuring netlogin on a X440G2, and some commands aren't show in the CLI 


1) the option "mode" dosn't exists 
configure netlogin ports 2:35 mode mac-based-vlans 

2) the option "vlan" dosn't exists 
configure netlogin vlan NAC-EXTREME 



* Slot-2 SW-A-1-1.54 # configure netlogin ports 2:35 (tab)
allowed-users Number of users allowed per port 
authentication Configure port authentication settings 
trap Enable/Disable/Prohibit trap on first rule use 

* Slot-2 SW-A-1-1.54 # configure netlogin (tab)
add Add a MAC-list entry 
agingtime Configure the time after which unauthenticated clients are removed 
allowed-refresh-failures Number of session refresh failures allowed before automatic logout 
authentication Configure Network Login client authentication settings 
banner Banner for Login Page 
base-url Base URL 
delete Delete a MAC-list entry 
dot1x Configure Network Login settings specific to 802.1X 
idle-timeout Set timeout for an idle session 
local-user Netlogin local user 
mac Configure Network Login settings specific to MAC 
ports Specify ports to add 
redirect-page Redirect Page 
session-refresh Session refresh time 
session-timeout Set timeout for an active session 
trap Set Network Login trap configuration 
web-based Configure the web-based authentication protocol
Photo of andrea rocchi

andrea rocchi

  • 70 Points

Posted 2 months ago

  • 0
  • 1
Photo of Karthik Mohandoss

Karthik Mohandoss, Employee

  • 5,998 Points 5k badge 2x thumb
Hi Andrea,

If policy is enabled these options will not be available.
Please check "show configuration policy" to disable use the command "disable policy" then the options to add netlogin vlan and mode should be available.

Regards,
Karthik