Netsight SNMP Config

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
I have  cleared all snmp default config on Enterasys switches.

clear snmp access ro security-model v1
clear snmp access ro security-model v2c
clear snmp access public security-model v1
clear snmp access public security-model v2c
clear snmp access public security-model usm
clear snmp group ro ro security-model v1
clear snmp group public public security-model v1
clear snmp group ro ro security-model v2c
clear snmp group public public security-model v2c
clear snmp group public public security-model usm
clear snmp user public
clear snmp community public

Then I set commands which is below.

set snmp group ABCgroup user ABC security-model usm nonvolatile
set snmp access ABCgroup security-model usm exact read All write All notify All nonvolatile
set snmp user ABC encryption des privacy 1234 authentication  md5 1234 

After these configuration I could not be able see switches on netsight. I am discovering the IP range of switches, but I can not find any switches.

Do I need to set any other command or do I have to do anything on Netsight server.

Thanks.
Photo of Erhan YILDIZ

Erhan YILDIZ

  • 366 Points 250 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Christoph

Christoph

  • 1,862 Points 1k badge 2x thumb
Two things:
You need to configure the view "All" on the Switch. Eg. "set snmp view viewname All subtree 1"

You need to set up a Netisght profile with the new credentials an assign it to the switch.