cancel
Showing results for 
Search instead for 
Did you mean: 

No station connects to my different SSIDs anymore

No station connects to my different SSIDs anymore

Peter_Kulmbrein
New Contributor II
No Client is able to connect to my different SSIDs anymore. Configuration is 2 V2110 on 10.31.05 in a FFO config - both up and running showing everything green and nothing in the log.
APs are 3805 connected and showing green - SSH possible and able to ping the Controller;

physical interface in a dedicated vlan with the APs w/o default Gateway

what i already tried i setting up a new Open SSID - but clients wont even connect to that open SSID.

no station event shown and when i wireshark on the AP i get an "Status code: The authentication has been declined (0x0025)" answer.

Anyone had that issue and knows how to solve it or knows anything about that behaviour?

Didn't have that before...

regards
Peter
9 REPLIES 9

Umut_Aydin
Extreme Employee
Hi,

does your client get IP addresses at all?
Promiscous mode enabled?
Can you ping the topology interfaces?

Do you use VMware?
Does it work before or is this a new setup? I assume yes.
Did you made any change on VMware/upgrade etc.?

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-configure-vSwitch-properties-For-V2...

Does it work if you reboot the AP?

Regards

Umut Aydin

As you can see above Ron guided me in the right direction - so I was able to solve the problem 😉

BR
Peter

Peter,

Do you still have the issues reported previously?

Hi Umut,

- IP Adress allocation does take place after connecting to the SSID i think
- i'll check for the promiscous mode Setting and i can ping the topo if
using VMware - paravirtual already selected if u mean that 😉
- we upgraded to 10.31.04 from 10.31.01 but downgrading didn't help
- no changes were made to the VMware enviroment

- am going to reboot all aps tomorrow

br
Peter
GTM-P2G8KFN