OneView Automatic Deployment

  • 0
  • 1
  • Problem
  • Updated 5 years ago
  • Solved
NetSight 5.1
C5-Series FW 6.81

When testing the new Automatic Deployment feature, the switch gets assigned an ip address by dhcpd but does not send a trap.

Tested this without option 125, send the trap to the dhcpd ip address.
Tested this with option 125 delivering the netsight ip address.

The network was monitored with wireshark.

I can clearly see the communication process between the switch and the dhcpd but as sson as the switch gets its ip address, there is no trap to be seen on the wire.
subnet netmask {
option vivso 00:00:15:F8:06:01:04:0A:00:00:02;
option subnet-mask;
option broadcast-address;
option routers;
This is my subnet definition in dhcpd can anyone spot something wrong there ??

Thanks Hans

Photo of Hans Meiser

Hans Meiser

  • 170 Points 100 badge 2x thumb

Posted 5 years ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 51,328 Points 50k badge 2x thumb
Official Response
Hans, I'm not an expert on the DHCP config but the subnet mask is not correct there is a typo... should be

As far as I'd see Netsight has IP and the client is in the subnet - could you try whether it work in the same subnet.

Kind regards,