Oneview Alarm

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
  • (Edited)
Hi all,

Conosle shows the sysname of alarm source but oneview does not!

Is there anyway to let the oneview show the sysname of alarm source instead of its IP address?

Thanks
Husam
Photo of Husam

Husam

  • 1,272 Points 1k badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Tony Thornton

Tony Thornton, Extreme Alumnus

  • 1,412 Points 1k badge 2x thumb
Hi Husam,

This Knowledge Base article may help:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-add-sysName-or-deviceNickName-into-...

You should be able to add the sysname and remove the IP if desired.

Regards
Tony
Photo of Husam

Husam

  • 1,272 Points 1k badge 2x thumb
Thank you for your answer.

I did mentioned configuration, but it works out for console only. For oneview it is still same problem. All alarms are showed IP address in source not sysname.

Is there any more thing could be done?

regards
Husam
Photo of Tony Thornton

Tony Thornton, Extreme Alumnus

  • 1,412 Points 1k badge 2x thumb
Husam,

Sorry this did not provide the results you were looking for.  I'm not sure of a way to have this information appear in OneView. Some functionality is migrating from Console to OneView as newer versions of NetSight are released.  This may not be one of them that has been migrated yet. 
You may want to open a new case with our GTAC group to confirm.

Regards
Tony
Photo of Frank Thomas

Frank Thomas

  • 72 Points
Hi Husam,
Just trying to make sure I understand what you're asking.
Do you have these two options checked and in Console the source shows host name of switch verse IP?


Or are you looking at the nickname field and that isn't present in Oneview?
Photo of Husam

Husam

  • 1,272 Points 1k badge 2x thumb
Hi,

Yes I have both of them checked. Sysname is shown in console alarm but is not shown in the oneview alarm!