cancel
Showing results for 
Search instead for 
Did you mean: 

Password not working after applying configure failsafe admin permit all command

Password not working after applying configure failsafe admin permit all command

Aneeq_Zia
New Contributor
Initially I configured admin password and it was working fine on x460 switch. As soon as I applied configure failsafe admin permit all command, password is no more working....?
12 REPLIES 12

Sumit_Tokle
Contributor
Note that in EXOS 21.1 and higher, a one-time failsafe exists. For information on this process, see How to access an EXOS switch using a one-time failsafe password

Ram3
Extreme Employee
Sounds good. Please make sure to configure it as per provided article.

yes, "config none" and then "boot" worked for me....

actually I tried "Config none" and than "Reboot", I think I should Try "boot" after "config none"
GTM-P2G8KFN