pim register checksum

  • 0
  • 1
  • Problem
  • Updated 2 years ago
  • Solved
Hi all,

Does any one of you ever encountered problem in having error message on "PIM register-checksum" on BD8k or summit x460 switches?

If yes,  may I know how to resolve this ? Please advice.

Best regards,
Dennis neo
Photo of Neo Dennis

Neo Dennis

  • 160 Points 100 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of David Coglianese

David Coglianese, Embassador

  • 7,208 Points 5k badge 2x thumb
Do
sho config pim detail on both switches

Make sure this line is the same on both "configure pim ipv6 register-checksum-to exclude-data"

Could also be one of these
configure pim register-checksum-to include-data
configure pim register-checksum-to exclude-data
Photo of Derek Bird

Derek Bird, Employee

  • 576 Points 500 badge 2x thumb
Dennis:

Have you taken a look at this article?

PIM Register message failed the checksum test
Photo of Neo Dennis

Neo Dennis

  • 160 Points 100 badge 2x thumb
yes, but either when I applied the command include-data or exclude-data the error PIM register checksum will change from one interface to another interface IP addresses. It is therefore become very difficult for me to troubleshoot in order to get the problem resolve....
Photo of Kevin Kim

Kevin Kim, Employee

  • 2,266 Points 2k badge 2x thumb
PIM register messages are exchanged from multicast source routers (the first hop routers) to RPs.
Photo of Drew C.

Drew C., Community Manager

  • 40,206 Points 20k badge 2x thumb
Hi Dennis,
Are you still having problems with this?  If so, it may be time to contact GTAC.
Photo of Neo Dennis

Neo Dennis

  • 160 Points 100 badge 2x thumb
Hi Kevin,
Thank you for your respond. We will try it out on site.
Best regards,
Dennis neo