Port Default Policy Role between Console and Policy Mngr is out-of-sync

  • 0
  • 1
  • Question
  • Updated 4 years ago
  • Answered
Why would Console and Policy Mngr differ when viewing the default port policy role that is being applied.  Policy Mngr is showing in one case 20 ports with a specific role and Console only shows the role on 10 of those ports
Photo of Walt Witkowski

Walt Witkowski

  • 416 Points 250 badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of Pala, Zdenek

Pala, Zdenek, Employee

  • 8,442 Points 5k badge 2x thumb
are all those ports the same king (physical). In PM there is option to show also virtual ports = LAG.

It should read the same OID from the mib, the data should be the same. Can you share the screenshot?

Z.
Photo of Walt Witkowski

Walt Witkowski

  • 416 Points 250 badge 2x thumb
Enterasys has confirmed that they are aware of this issue. I am running Netsight 5.1 and Netsight ver.6.1 is in the works with a fix. Screen shots are available in the case 01021283. Clarification... When viewing Netsight Console the "BasicPolicy" tab all the ports set to have a specific default role do not show the role, under the "Default Role" column. If I SSH to the switch (C3) and do a "show config policy" the "set policy port xx.x x is there for every port intended. The Netsight Policy Mngr. also shows all the intended ports for the role when I select a role and under the "ports" tab do a retrieve operation.