Port Sharing issue

  • 0
  • 1
  • Question
  • Updated 4 years ago
Create Date: Apr 11 2012 9:44PM

Hello Guys,

I have BD8810 (XOS ver: 12.3.3.6) switch on which servers are connected , we have few serves with multiple LAN ports with teaming enabled and in load balance mode.

i did port sharing for coupling 2 switch port for getting 2GBPS through put ,command i used is ' enable sharing 1:41 grouping 1:41-42 algorithm address-based L2'

but while checking traffic on server LAN cards .. on both lan cards i saw Sent packets but received packets are seen on only 1 lan card of server

both ports connected on same switch

Pls let me know if i have to do any twicking at switch side configuration ?



Thanks

Deepak

(from Deepak_Patkar)
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb

Posted 4 years ago

  • 0
  • 1
Photo of EtherNation User

EtherNation User, Employee

  • 20,340 Points 20k badge 2x thumb
Create Date: Apr 11 2012 11:58PM

<p> Is the server end also using address based L2? Make sure that's the case</p>
<p>verify the output of "show port utilization". see the Tx and RX packets on both ports.</p>
<p>Also "show vlan <Vlan name>" for the vlan that contains these ports and verify if one of the ports is blocked or not. It will show (g) for sharing and (gb) for blocked port.</p>

(from Arpit_Bhatt)

This conversation is no longer open for comments or replies.