cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Problem with stack between X250 - X440

Problem with stack between X250 - X440

Leonardo_Falcon
New Contributor II
Hello people,
I have two switches in stack.
The switches are X250e-24t and X440-48p.
The version is 15.3.2.11.
This stack has two ports in trunk configured in sharing to the switch core.
The spanning tree is not configured in this network.
One week ago I had a problem because there were a l2 loop.
I think it was a stack problem, causing the misconfiguration of the two ports in sharing and lease two trunk actived.
What do you think?
Are there problems if I do a stack with two platform different?
If I upgrade the version, Can I resolve this problem?
Thank you.

5 REPLIES 5

Leonardo_Falcon
New Contributor II
Hi Drew,
I have upgraded the version and until now the problem is not appeared.
Thank you.

Drew_C
Valued Contributor III
Hi Leonardo,
Were you able to resolve this issue, or do you still need assistance?

Ronald_Dvorak
Honored Contributor
could you share the output of "show stacking"

Vellachery__Sum
Extreme Employee
Leonardo,

Adding to my colleagues suggestion (Karthik). Also, look for the stacking port Rx errors & Tx errors are getting incremented:-
  • show ports stack-ports rxerrors no-refresh
  • show ports stack-ports txerrors no-refresh

8c475ab7ecd3415880daf59ba6b860e2_RackMultipart20161229-112466-1sqyjrd-Capture_1_inline.png



In case, if the Rx errors are getting incremented. Check stacking cables for good connections, firmly connected with the screws tightened.
If you have a spare stacking cable. Try swapping them with the spare one and monitor the stacking ports Rxerrors

GTM-P2G8KFN