Purview Dual Interface Mirrored not showing application and network response time

  • 0
  • 1
  • Problem
  • Updated 8 months ago
  • Not a Problem
In trying to set up Purview, I am getting the flows in netsight.  It is not showing response times for network or applications.  It could be a configuration issue as this is my first time really diving into Purview.  

I have it configured in Dual Interface Mirrored.  I am seeing traffic on eth0 and eth1.

Below is my configuration:


# mirror
set mirror create 1
set mirror 1 mirrorN 15
set mirror ports ge.1.1 1


# netflow
set netflow export-interval 1
set netflow export-destination 192.168.10.53 2055
set netflow export-version 9
set netflow port ge.1.36 enable rx
set netflow template refresh-rate 30 timeout 1
set netflow cache enable

Jumbo frames, port duplex, and port speed have all been set.

I have one port going from one of my cisco switches in the network to an SSA. I have the span set for both at the moment on the one port.  I have also tried 2 ports between with rx on one and tx on the other.  Still have the same result. 
Photo of Jeremy Evans

Jeremy Evans

  • 80 Points 75 badge 2x thumb

Posted 8 months ago

  • 0
  • 1
Photo of Jeremy Evans

Jeremy Evans

  • 80 Points 75 badge 2x thumb
I failed to mention that this is a virtual appliance on vmware.  Promiscuous mode and jumbo frames are enabled on here also.