Purview no application detected.

  • 0
  • 1
  • Problem
  • Updated 2 years ago
  • Solved
Cannot detect application on purview. "Port mirroring does not appear to be set up correctly on gre1"
Photo of Marlon

Marlon

  • 1,570 Points 1k badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Matthew Hum

Matthew Hum, Principal Engineer, APAC

  • 1,542 Points 1k badge 2x thumb
This means there is no traffic coming in on the GRE tunnel between the Flow Collector/SSA and the Purview appliance.
Please check/post the SSA/FC configuration to ensure that traffic is being mirrored properly.

You can also check the Purview Deployment Guide to compare the configuration against the example deployments.
Photo of Mike Thomas

Mike Thomas, Employee - GTAC - NMS

  • 7,476 Points 5k badge 2x thumb
Photo of Marlon

Marlon

  • 1,570 Points 1k badge 2x thumb
Hi All,


thanks! now its working.
Photo of Mike Thomas

Mike Thomas, Employee - GTAC - NMS

  • 7,476 Points 5k badge 2x thumb
Marlon, can you tell us what changed in order for this to start working? It may help others reviewing the Hub. Thanks!
Photo of aloeffle

aloeffle

  • 934 Points 500 badge 2x thumb
Hi all.

please not, that if you use L2 GRE Tunnel to transmit the mirrored traffic to purview and if your gre port is an "  tg.*.*  " port you need to insert an 10GE optic. It will not work with an 1GE optic.

even if the tg.*.* port is up and also the tunnel interface is up. no applications are detected and no fingerprints will match.

Save some time in troubleshooting, insert an 10GE optic and reset the tunnel interface. Then you will see some applications.